User manual

13
2.3 Installing passive backplane & CPU card
The ACP-4320BP accepts an up to 15-slot backplane. To install a back-
plane and a CPU card, proceed as follows:
2.3.1 Installing the backplane
1. Remove the two screws, which mount the hold-down clamp to the
ACP-4320BP chassis, then take out the hold-down clamp.
2. Find the yellow label (shown as Table 2.1) on the upperplate of the
ACP-4320BP chassis. This label instructs where to screw the copper
stubs on the upperplate, based on the to-be-installed backplane and
motherboard. Get the copper stubs from the accessory box of the
ACP-4320BP packing, and follow the table to screw the copper stubs
on the proper locations on the upperplate.
Figure 2.3: Installing a backplane
3. Refer to Figure 2.3, carefully place the backplane and the EMI spring
plate into the ACP-4320BP chassis. For the bare ACP-4320BP chas-
sis, the EMI spring plate is stored in the accessory box.
4. Fix the backplane with screws.