User manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Hardware Functionality
- 2.1 Introduction of ARK-3380 External I/O Connectors
- 2.2 ARK-3380 front metal face plate external I/O connectors
- 2.3 ARK-3380 rear metal face plate external I/O connectors
- Chapter 3 Hardware Installation and Upgrade
- 3.1 Jumpers and Connectors
- 3.2 Setting jumpers
- 3.3 COM2 RS-232/422/485 Jumper setting (J3/J4/J5)
- 3.4 LCD Power Jumper Setting (J6)
- 3.5 NTSC/PAL TV type Setting (J1)
- 3.6 Installing the DDR SDRAM Memory Module
- 3.7 Inserting a Compact Flash Card
- 3.8 Installing the 2.5" Hard Disk Drive (HDD)
- 3.9 Connecting Power
- Chapter 4 Award BIOS Setup
- 4.1 Introduction
- 4.2 Entering Setup
- 4.2.1 Main Menu
- 4.2.2 Standard CMOS Features
- 4.2.3 Advanced BIOS Features
- 4.2.4 Advanced Chipset Features
- 4.2.5 Integrated Peripherals
- 4.2.6 Power Management Setup
- 4.2.7 PnP/PCI Configurations
- 4.2.8 Frequency/Voltage Control
- 4.2.9 Load Optimized Defaults
- 4.2.10 Set Password
- 4.2.11 Save & Exit Setup
- 4.2.12 Quit Without Saving
- Chapter 5 PCI SVGA/LCD Setup
- Chapter 6 Full Disassembly Procedure
ARK-3380 User Manual 4
Speed: 10/100MBps, IEEE 802.3u (100 BASE-T) protocol compatible
1.3.4 Audio
Audio Interface
• Audio controller on the ICH4 chip
• AC97 3D surround stereo sound, Dual 6 W Amplifier
• Supports Line_In, Speaker_Out, and Microphone_In
1.3.5 Other
Watchdog Timer: 255 levels timer interval, setup by software
Serial Port: One RS-232 port (COM1) and One RS-232/422/485 port
(COM2)
Note: The default setting of COM2 is RS-232. The RS-422/485
mode of COM2 can be support via replacing the internal cable and
adjust the jumper inside of system.
Keyboard/Mouse: One PS/2 Port to support PS/2 Mouse and PS/2 Key-
board
USB: Three USB 2.0 compliant universal Serial bus port
DIO: ARK-3380 provides one D-sub 8 Bits Female connectors, which
offers Digital IO communication interface ports. If you want to use DIO,
you can find the Pin assignment as following
1.3.6 Storage
• Supports a drive bay space for 2.5’’ HDD
• Supports a CompactFlash socket for Type I/II CompactFlash disk
1.3.7 Mechanical
Construction: Aluminum housing
Mounting: DIN-rail mounting, Desk/wall mounting
Dimension (W x H x D): 264.5 mm x 69.2 mm x 137.25 mm ( 10.41”x
2.72”x 4.4” )
Weight: Net 2 KG
1.3.8 Power Supply
• Output Rating 46 W, ATX support
• Fuse Rating 7 A @ 125 V
• Input Voltage: 12 VDC ~ 24 VDC,
- Typical:
12 VDC @ 4.5A,