User manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Hardware Functionality
- 2.1 Introduction of ARK-3380 External I/O Connectors
- 2.2 ARK-3380 front metal face plate external I/O connectors
- 2.3 ARK-3380 rear metal face plate external I/O connectors
- Chapter 3 Hardware Installation and Upgrade
- 3.1 Jumpers and Connectors
- 3.2 Setting jumpers
- 3.3 COM2 RS-232/422/485 Jumper setting (J3/J4/J5)
- 3.4 LCD Power Jumper Setting (J6)
- 3.5 NTSC/PAL TV type Setting (J1)
- 3.6 Installing the DDR SDRAM Memory Module
- 3.7 Inserting a Compact Flash Card
- 3.8 Installing the 2.5" Hard Disk Drive (HDD)
- 3.9 Connecting Power
- Chapter 4 Award BIOS Setup
- 4.1 Introduction
- 4.2 Entering Setup
- 4.2.1 Main Menu
- 4.2.2 Standard CMOS Features
- 4.2.3 Advanced BIOS Features
- 4.2.4 Advanced Chipset Features
- 4.2.5 Integrated Peripherals
- 4.2.6 Power Management Setup
- 4.2.7 PnP/PCI Configurations
- 4.2.8 Frequency/Voltage Control
- 4.2.9 Load Optimized Defaults
- 4.2.10 Set Password
- 4.2.11 Save & Exit Setup
- 4.2.12 Quit Without Saving
- Chapter 5 PCI SVGA/LCD Setup
- Chapter 6 Full Disassembly Procedure
29 Chapter 3
5. Insert the CF Carrier back and assemble with 2 screws to the CF
door located on rear face plate of the ARK-3380.
Note: The CompactFlash socket is allocated as Secondary IDE Master.
3.8 Installing the 2.5" Hard Disk Drive (HDD)
You can attach one Serial ATA (SATA) hard disk drive to the ARK-3380's
internal controller. The following are instructions for installation:
1. Remove the power cord.
2. Unscrew the four screws from bottom cover of the ARK-3380.
3. Remove the bottom cover of the ARK-3380.
4. Connect the SATA flat cable to the connector to the hard disk.
5. Screw back the bottom cover with the four screws.
3.9 Connecting Power
Connect the ARK-3380 to a 12~24 VDC power source. The power source
can either be from a power adapter or an in-house power source.