User manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Hardware Functionality
- 2.1 Introduction of ARK-3380 External I/O Connectors
- 2.2 ARK-3380 front metal face plate external I/O connectors
- 2.3 ARK-3380 rear metal face plate external I/O connectors
- Chapter 3 Hardware Installation and Upgrade
- 3.1 Jumpers and Connectors
- 3.2 Setting jumpers
- 3.3 COM2 RS-232/422/485 Jumper setting (J3/J4/J5)
- 3.4 LCD Power Jumper Setting (J6)
- 3.5 NTSC/PAL TV type Setting (J1)
- 3.6 Installing the DDR SDRAM Memory Module
- 3.7 Inserting a Compact Flash Card
- 3.8 Installing the 2.5" Hard Disk Drive (HDD)
- 3.9 Connecting Power
- Chapter 4 Award BIOS Setup
- 4.1 Introduction
- 4.2 Entering Setup
- 4.2.1 Main Menu
- 4.2.2 Standard CMOS Features
- 4.2.3 Advanced BIOS Features
- 4.2.4 Advanced Chipset Features
- 4.2.5 Integrated Peripherals
- 4.2.6 Power Management Setup
- 4.2.7 PnP/PCI Configurations
- 4.2.8 Frequency/Voltage Control
- 4.2.9 Load Optimized Defaults
- 4.2.10 Set Password
- 4.2.11 Save & Exit Setup
- 4.2.12 Quit Without Saving
- Chapter 5 PCI SVGA/LCD Setup
- Chapter 6 Full Disassembly Procedure
ARK-3380 User Manual 36
• Total Memory
This item displays the total system memory size.
4.2.3 Advanced BIOS Features
• CPU Feature
This item allows the user to adjust CPU features, CPU ratio, VID and
Thermal and special features such as XD flag.
• Virus Warning [Disabled]
This item allows the user to choose the VIRUS Warning feature for
IDE Hard Disk boot sector protection.
• CPU L1 & L2 Cache [Enabled]
This item allows the user to enable CPU L1 & L2 cache.
• CPU L3 Cache [Enabled]
This item allows the user to enable CPU L3 cache.
• Quick Power On Self Test [Enabled]
This field speeds up the Power-On Self Test (POST) routine by skip-
ping retesting a second, third and fourth time. Default is enabled.
• First / Second / Third Boot Device
Assign bootup priorities.
Floppy Floppy drive gets this priority.
LS120 LS120 gets this priority.
Hard Disk Hard Disk gets this priority.
CDROM CDROM gets this priority.
ZIP ZIP drive gets this priority.
USB-FDD USB-FDD gets this priority.
USB-ZIP USB-ZIP gets this priority.
USB-CDROM USB-CDROM gets this priority.
USB-HDD USB-HDD gets this priority.
LAN LAN gets this priority.
Disabled Disable this boot function.
• Boot Other Device [Enabled]
Use this to add yet another device to the bootup queue. If First, Second,
and Third Boot Devices are not present or fail, the system will boot
from the next available device.