User manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Hardware Functionality
- 2.1 Introduction of ARK-3380 External I/O Connectors
- 2.2 ARK-3380 front metal face plate external I/O connectors
- 2.3 ARK-3380 rear metal face plate external I/O connectors
- Chapter 3 Hardware Installation and Upgrade
- 3.1 Jumpers and Connectors
- 3.2 Setting jumpers
- 3.3 COM2 RS-232/422/485 Jumper setting (J3/J4/J5)
- 3.4 LCD Power Jumper Setting (J6)
- 3.5 NTSC/PAL TV type Setting (J1)
- 3.6 Installing the DDR SDRAM Memory Module
- 3.7 Inserting a Compact Flash Card
- 3.8 Installing the 2.5" Hard Disk Drive (HDD)
- 3.9 Connecting Power
- Chapter 4 Award BIOS Setup
- 4.1 Introduction
- 4.2 Entering Setup
- 4.2.1 Main Menu
- 4.2.2 Standard CMOS Features
- 4.2.3 Advanced BIOS Features
- 4.2.4 Advanced Chipset Features
- 4.2.5 Integrated Peripherals
- 4.2.6 Power Management Setup
- 4.2.7 PnP/PCI Configurations
- 4.2.8 Frequency/Voltage Control
- 4.2.9 Load Optimized Defaults
- 4.2.10 Set Password
- 4.2.11 Save & Exit Setup
- 4.2.12 Quit Without Saving
- Chapter 5 PCI SVGA/LCD Setup
- Chapter 6 Full Disassembly Procedure
37 Chapter 4
• Boot Up NumLock Status [On]
When ON, system boots to keypad NumLock activated.
• Gate A20 Option [On]
Options are On (default), and Off.
On means that the chipset controls GateA20, and gives fast GateA20
speed.
Off means that the keyboard controller controls GateA20. This gives
normal GateA20 speed.
• Typematic Rate Setting
This item enables users to set the two typematic control items.
- Typematic Rate (Chars/Sec)
This item controls the speed at which system registers repeated key-
strokes.
The eight settings are 6, 8, 10, 12, 15, 20, 24 and 30.
- Typematic Delay (Msec)
This item sets the time interval before automatic character repetition
kicks in. The four delay options are 250, 500, 750 and 1000.
• Security Option [Setup]
System System will not boot and will not access Setup page unless
the correct password is entered at the prompt.
Setup System will boot, but access to Setup is denied unless cor-
rect password is entered at the prompt. (Default value)
• ACPI Mode [Enable]
This item sets the operating in Advanced Configuration and Power
Interface in Windows 2000-based computer for power saving Function.