User manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Hardware Functionality
- 2.1 Introduction of ARK-3380 External I/O Connectors
- 2.2 ARK-3380 front metal face plate external I/O connectors
- 2.3 ARK-3380 rear metal face plate external I/O connectors
- Chapter 3 Hardware Installation and Upgrade
- 3.1 Jumpers and Connectors
- 3.2 Setting jumpers
- 3.3 COM2 RS-232/422/485 Jumper setting (J3/J4/J5)
- 3.4 LCD Power Jumper Setting (J6)
- 3.5 NTSC/PAL TV type Setting (J1)
- 3.6 Installing the DDR SDRAM Memory Module
- 3.7 Inserting a Compact Flash Card
- 3.8 Installing the 2.5" Hard Disk Drive (HDD)
- 3.9 Connecting Power
- Chapter 4 Award BIOS Setup
- 4.1 Introduction
- 4.2 Entering Setup
- 4.2.1 Main Menu
- 4.2.2 Standard CMOS Features
- 4.2.3 Advanced BIOS Features
- 4.2.4 Advanced Chipset Features
- 4.2.5 Integrated Peripherals
- 4.2.6 Power Management Setup
- 4.2.7 PnP/PCI Configurations
- 4.2.8 Frequency/Voltage Control
- 4.2.9 Load Optimized Defaults
- 4.2.10 Set Password
- 4.2.11 Save & Exit Setup
- 4.2.12 Quit Without Saving
- Chapter 5 PCI SVGA/LCD Setup
- Chapter 6 Full Disassembly Procedure
ARK-3380 User Manual 44
4.2.7 PnP/PCI Configurations
Note: This “PnP/PCI Configurations” screen is for setting up the IRQ
and DMA (both PnP and PCI) bus assignments.
• Reset Configuration Data [Disabled]
This item allows the user to clear any PnP configuration data stored in
the BIOS.
• Resources Controlled By [Auto (ESCD)]
- IRQ Resources
This item allows the user to assign interrupt types to IRQ-3, 4, 5, 7, 9,
10, 11, 12, 14, and 15, respectively.
- PCI / VGA Palette Snoop [Disabled]
The item is designed to solve problems caused by some non-standard
VGA cards. A built-in VGA system does not need this function.
4.2.8 Frequency/Voltage Control
Note: This “Frequency/Voltage Control” option controls the CPU Host
and PCI frequency, this page is CPU and Chipset dependent; some items
will show up when a processor which supports those items is installed.
• Auto Detect PCI Clk [Enabled]
This item enables or disables automatic PCI clock detection.
• Spread Spectrum [Disabled]
This item enables or disables spread spectrum modulation.
• CPU Host/3V66/PCI Clock [Default]
This item enables users to set the CPU Host, AGP and PCI clock, either
by automatic detection or manually.