User manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Hardware Functionality
- 2.1 Introduction of ARK-3380 External I/O Connectors
- 2.2 ARK-3380 front metal face plate external I/O connectors
- 2.3 ARK-3380 rear metal face plate external I/O connectors
- Chapter 3 Hardware Installation and Upgrade
- 3.1 Jumpers and Connectors
- 3.2 Setting jumpers
- 3.3 COM2 RS-232/422/485 Jumper setting (J3/J4/J5)
- 3.4 LCD Power Jumper Setting (J6)
- 3.5 NTSC/PAL TV type Setting (J1)
- 3.6 Installing the DDR SDRAM Memory Module
- 3.7 Inserting a Compact Flash Card
- 3.8 Installing the 2.5" Hard Disk Drive (HDD)
- 3.9 Connecting Power
- Chapter 4 Award BIOS Setup
- 4.1 Introduction
- 4.2 Entering Setup
- 4.2.1 Main Menu
- 4.2.2 Standard CMOS Features
- 4.2.3 Advanced BIOS Features
- 4.2.4 Advanced Chipset Features
- 4.2.5 Integrated Peripherals
- 4.2.6 Power Management Setup
- 4.2.7 PnP/PCI Configurations
- 4.2.8 Frequency/Voltage Control
- 4.2.9 Load Optimized Defaults
- 4.2.10 Set Password
- 4.2.11 Save & Exit Setup
- 4.2.12 Quit Without Saving
- Chapter 5 PCI SVGA/LCD Setup
- Chapter 6 Full Disassembly Procedure
51 Chapter 5
5.2.1 Installation of Windows 98/Me
1. Find Win98/Me VGA driver from CD at the directory of ARK-
3380 CD, VGA\Win9x_ME\Graphics\Setup
Figure 5.4: Directory “Graphics”
Notes: 1. The windows illustrations in this chapter are intended as
examples only. Please follow the listed steps, and pay attention to the
instructions which appear on your screen. 2. For convenience, the CD-
ROM drive is designated as "D" throughout this chapter.