User manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Hardware Functionality
- 2.1 Introduction of ARK-3380 External I/O Connectors
- 2.2 ARK-3380 front metal face plate external I/O connectors
- 2.3 ARK-3380 rear metal face plate external I/O connectors
- Chapter 3 Hardware Installation and Upgrade
- 3.1 Jumpers and Connectors
- 3.2 Setting jumpers
- 3.3 COM2 RS-232/422/485 Jumper setting (J3/J4/J5)
- 3.4 LCD Power Jumper Setting (J6)
- 3.5 NTSC/PAL TV type Setting (J1)
- 3.6 Installing the DDR SDRAM Memory Module
- 3.7 Inserting a Compact Flash Card
- 3.8 Installing the 2.5" Hard Disk Drive (HDD)
- 3.9 Connecting Power
- Chapter 4 Award BIOS Setup
- 4.1 Introduction
- 4.2 Entering Setup
- 4.2.1 Main Menu
- 4.2.2 Standard CMOS Features
- 4.2.3 Advanced BIOS Features
- 4.2.4 Advanced Chipset Features
- 4.2.5 Integrated Peripherals
- 4.2.6 Power Management Setup
- 4.2.7 PnP/PCI Configurations
- 4.2.8 Frequency/Voltage Control
- 4.2.9 Load Optimized Defaults
- 4.2.10 Set Password
- 4.2.11 Save & Exit Setup
- 4.2.12 Quit Without Saving
- Chapter 5 PCI SVGA/LCD Setup
- Chapter 6 Full Disassembly Procedure
ARK-3380 User Manual 58
5. Unscrew the 2 screws which are located on the Front Metal Face
plate.
6. The Front Metal Face Plate removed.
Warning: Do not use too much pressure when removing the front metal
face plate as the power button cable is still attached and could be dam-
aged.
7. Unscrew the 4 screws of the frame bracket on the rear side of sys-
tem.