User manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Hardware Functionality
- 2.1 Introduction of ARK-3380 External I/O Connectors
- 2.2 ARK-3380 front metal face plate external I/O connectors
- 2.3 ARK-3380 rear metal face plate external I/O connectors
- Chapter 3 Hardware Installation and Upgrade
- 3.1 Jumpers and Connectors
- 3.2 Setting jumpers
- 3.3 COM2 RS-232/422/485 Jumper setting (J3/J4/J5)
- 3.4 LCD Power Jumper Setting (J6)
- 3.5 NTSC/PAL TV type Setting (J1)
- 3.6 Installing the DDR SDRAM Memory Module
- 3.7 Inserting a Compact Flash Card
- 3.8 Installing the 2.5" Hard Disk Drive (HDD)
- 3.9 Connecting Power
- Chapter 4 Award BIOS Setup
- 4.1 Introduction
- 4.2 Entering Setup
- 4.2.1 Main Menu
- 4.2.2 Standard CMOS Features
- 4.2.3 Advanced BIOS Features
- 4.2.4 Advanced Chipset Features
- 4.2.5 Integrated Peripherals
- 4.2.6 Power Management Setup
- 4.2.7 PnP/PCI Configurations
- 4.2.8 Frequency/Voltage Control
- 4.2.9 Load Optimized Defaults
- 4.2.10 Set Password
- 4.2.11 Save & Exit Setup
- 4.2.12 Quit Without Saving
- Chapter 5 PCI SVGA/LCD Setup
- Chapter 6 Full Disassembly Procedure
ARK-3380 User Manual 60
10. Unscrew the 2 screws which are located on the Rear Metal Face
plate.
11. Disassembly the 2 screws which fixed the “COM2 port” on the
Rear Metal Face Plate.
Warning: Do not use too much pressure when removing the front metal
face plate as the COM2 connector cable is still attached and could be
damaged.
12. The rear Metal Face Plate removed.