User manual

25 Chapter 3
5. Insert the CF Carrier back and assemble with 2 screws to the CF door
located on rear face plate of the ARK-3380
Figure 3.4:
Note: The CompactFlash socket is allocated as Secondary IDE Master.
3.8 Installing the 2.5" Hard Disk Drive (HDD)
You can attach one enhanced Integrated Device Electronics (IDE) hard
disk drive to the ARK-3380's internal controller which uses a PCI local-
bus interface. The advanced IDE controller supports faster data transfer
and allows the IDE hard drive to exceed 528 MB. The following are
instructions for installation:
1. Remove the power cord.
2. Unscrew the four screws from bottom cover of the ARK-3380.
3. Remove the bottom cover of the ARK-3380.
4. Connect the IDE flat cable to the connector to the hard disk.
5. Screw back the bottom cover with the four screws.
3.9 Connecting Power
Connect the ARK-3380 to a 12~24 VDC power source. The power source
can either be from a power adapter or an in-house power source.