User manual

ARK-3390 User Manual 32
3.2.7 PnP/PCI Configurations
 Init Display First [PCI Slot]
This item is for setting start up video output from the PCI or onboard device.
 Reset Configuration Data [Disabled]
This item allows the user to clear any PnP configuration data stored in the BIOS.
 Resources Controlled By [Auto(ESCD)]
The commands here are “Auto(ESCD)” or “Manual”. Choosing “Manual”
requires you to choose resources from the following sub-menu. “Auto(ESCD)”
automatically configures all of the boot and Plug and Play devices, but you must
be using Windows 95 or above.
– IRQ Resources
This item allows you respectively assign an interrupt type for IRQ-3, 4, 5, 7,
9, 10, 11, 12, 14, and 15.
– DMA Resources
This item allows you respectively assign an interrupt type for DMA-0, 1, 2, 3,
4, 5, 6, and 7.
 PCI VGA Palette Snoop [Disabled]
The item is designed to solve problems caused by some non-standard
VGA cards. A built-in VGA system does not need this function.
 NT Pin 1~8 Assignment [Auto]
This item allows the user to select the interrupt request (IRQ) assigned to a
device connected to the PCI interface on your system.
 Maximum Payload Size [4096]
This item allows the user to adjust maximum TLP (Transaction Layer Packet)
payload size.
Note! The "PnP/PCI Configurations" screen sets up the IRQ and DMA (both
PnP and PCI bus assignments).