Operating Instructions
Table Of Contents
- 1. Introduction
- 2. Technical customer support
- 3. Functional description
- 4. Unpacking, transporting, storing
- 5. Technical data – Device
- 6. Technical data – Radio modules (all optional)
- 7. Operation
- 8. General device configuration
- 9. Wi-Fi configuration
- 10. WWAN configuration
- 11. Mechanical installation
- 12. Electrical installation, cable connection, cable cover
- 13. Connectors
- 14. Integrated power supply, power supply cable
- 15. Optional equipment
- 16. Maintenance
- 17. Malfunctions and troubleshooting
- 18. Reasonably foreseeable misuse
- 19. Guidelines and certificates
- 20. End-of-life device disposal
- 21. List of figures
Electrical installation, cable connection, cable cover
108 / 140 DLT-V72 Operating Instructions V2.50 Preliminary
12.4.2. Ethernet cable
Plug the Ethernet cable into the associated port.
Fold open the round cable passage in the rubber seal.
Insert the Ethernet cable.
Secure Ethernet cable to the strain relief rail with cable clips and screws.
ATTENTION Tighten the mounting screws sufficiently but on no account pinch or crush the cable.
If you do, the cables may break or the cable insulation may get damaged.
Fig. 12.6: Ethernet cable on the connector panel; secured to the strain relief rail
12.4.3. COM cable
Plug the required COM cable into the associated port.
Fold open the respective round cable passage in the rubber seal.
Insert the COM cable.
Secure the COM cable to the strain relief rail with cable clips and screws.
ATTENTION Tighten the mounting screws sufficiently but on no account pinch or crush the cable.
If you do, the cables may break or the cable insulation may get damaged.
Fig. 12.7: COM cable on the connector panel; secured to the strain relief rail