Operating Instructions
Table Of Contents
- 1. Introduction
- 2. Technical customer support
- 3. Functional description
- 4. Unpacking, transporting, storing
- 5. Technical data – Device
- 6. Technical data – Radio modules (all optional)
- 7. Operation
- 8. General device configuration
- 9. Wi-Fi configuration
- 10. WWAN configuration
- 11. Mechanical installation
- 12. Electrical installation, cable connection, cable cover
- 13. Connectors
- 14. Integrated power supply, power supply cable
- 15. Optional equipment
- 16. Maintenance
- 17. Malfunctions and troubleshooting
- 18. Reasonably foreseeable misuse
- 19. Guidelines and certificates
- 20. End-of-life device disposal
- 21. List of figures
General device configuration
46 / 140 DLT-V72 Operating Instructions V2.50 Preliminary
8. General device configuration
WARNING
Risk of injury and damage due to improper configuration.
These instructions are directed to skilled personnel.
Only qualified skilled personnel (e.g. IT personnel with good knowledge of PCs, operating
systems and wireless networks) may configure the DLT-V72.
If the DLT-V72 is incorrectly configured, warranty for this device will be void.
8.1. Operating systems available (optional)
Please find the latest overview of all supported operating systems in the DLT-V72
data sheets on our websites.
The following operating systems are available at the time of manual creation, Feb 2019:
− Windows 10 IoT Enterprise
− Windows 7 Pro
− Windows Embedded Standard 7
− Debian-based Linux
− IGEL Linux
8.2. MS-Windows (optional)
8.2.1. General
If a DLT-V72 with preinstalled operating system is placed into operation, this operating system will be
loaded after the BIOS system messages. System-specific device drivers (e.g. for graphics, sound,
network, touchscreen) are already installed.
In DLT-V72 units with a pre-installed operating system, the system is located on the C partition.
When a DLT-V72 is started up for the first time without a pre-installed operating system, the user needs
to carry out a number of steps that will vary depending on the system to be installed. Refer to the
relevant operating system manual for specific instructions.
8.2.2. Configuring the front keys, automatic shutdown, etc.
The DLoG Config software is used to configure DLT-V72 devices with a Microsoft Windows operating
system.
For configuring DLT-V72, the DLoG Config version 5.0 or higher is required.
Configuration examples:
− Automatic shut down
− Wi-Fi status display