User's Manual

Mechanical Installation
DLT-V72 Series User Manual V2.74
141 / 189
12.1. Safety notes
WARNING
Risk of personal injury and property damage due to improper
mechanical installation.
These mounting instruction are directed to skilled personnel. Only
qualified skilled personnel may perform the mechanical installation
work on the DLT-V72.
1. Observe manual section 2.5 Information on safe mounting.
NOTICE
Prevent system malfunction and property damage
The front display of the DLT-V72 is protected during transport by a
transparent film. This film should remain on the front display during
assembly to avoid damage to the front display surface.
Only remove the film after all of the installation work has been
completed.
12.2. Overview: Recommended mounting sequence
Requirement: The vehicle/installation location must be prepared (e.g. connection to the
ignition, correct voltage, etc.)
1. Find a suitable installation position for the DLT-V72.
2. Secure the device mounting (RAM or mounting bracket) to the targeted
subject/vehicle.
3. Connect external accessories to the DLT-V72.
4. Install an easily accessible disconnecting device such as a switch close to
the device.
5. Connect all cables (power supply, peripherals).
6. Close off all unused cable openings of the rubber seal using the
accompanying blind plugs so that they are sealed.
7. Close the DLT-V72 with the cable cover.
8. Install the DLT-V72 on the device mounting.