User's Manual

Safety Instructions
DLT-V4108 Industrial PC
6 / 8
Safety Instructions DLT-V4108, V01 PN2005410800
Advantech-DLoG
Observe the following instructions when
connecting/removing external devices.
 Only use accessories that have been
tested and approved by Advantech-
DLoG for the respective DLT-V4108
 DLT-V4108 may not be connected to
power supply if external devices are
being connected/ removed (not
applicable for USB devices). Otherwise
considerable damage could be caused
to both DLT-V4108 and the peripheral
devices
 Make sure that peripherals with their
own power supply are either switched
on at the same time as DLT-4108 or
after the start of DLT-V4108.
 Otherwise, you must ensure that a
backflow from the external device to
DLT-V4108 system cannot take place.
 Only power up DLT-V4108 when all
devices have been connected and
DLT-V4108 has been closed correctly
(remember the cable cover!).
Otherwise, you may damage DLT-
V4108.
5
Handling / Operation
NOTICE: Physical damage
Improper operation can cause damage and
downtimes to the DLT-V4108 and to the
connected complete system.
 Operators of the DLT-V4108 must be
trained in the handling of the device.
Different temperature and air humidity.
If DLT-V4108 is alternately used between very
different temperature and air humidity condition,
condensation may form on or within DLT-
V4108.
 To prevent damaging DLT-V4108, you
will need to wait sufficient time for the
moisture to evaporate before using
DLT-V4108.
Cables
 Be sure that nothing rests on power
cable and the cable is not located in
where it can be tripped over or stepped
on.
 When you disconnect any cable, pull
on its connector or on its strain relief
loop.
 Do not pull on the cable itself. As you
pull out the connector, keep it evenly
aligned to avoid bending any connector
pin.
 Also, before you connect any cable,
please make sure that both connectors
are correctly oriented and aligned.
 Use available strain relief rails.
6
Maintenance
WARNING
Only the manufacturer and its authorized
service centers may:
 Conduct repairs.
 Carry out modifications.
 Replace modules.
 Open the device.