User manual

Port Statistics
The following information provides the current port statistics.
• Port: Displays the port number.
•
Type:
Displays the media type of the port.
• Link: The status of linking—‘Up’ or ‘Down’.
• State: The user can set the state of the port to ‘Enable’ or ‘Disable’ via the Port Control section. When
the state is disabled, the port will not transmit or receive any packet.
• Tx Good Packet: The counts of transmitting good packets via this port.
• Tx Bad Packet: The counts of transmitting bad packets (including undersize [less than 64 bytes],
oversize, CRC Align errors, fragments and jabbers packets) via this port.
• Rx Good Packet: The counts of receiving good packets via this port.
• Rx Bad Packet: The counts of receiving bad packets (including undersize [less than 64 bytes],
oversize, CRC error, fragments and jabbers) via this port.
• Tx Abort Packet: The aborted packet while transmitting.
• Packet Collision: The counts of collision packet.
• CRC Error: The counts of cyclic redundancy check errors.
• Fragments: The counts of non-complete packets.
•
Click
Clea
r
to clean all counts.
Figure 3.1-16 Port Statistics
37 Chapter3