User manual

Port Control
In Port Control, you can select ports and click the pull-down menus to set parameters of each port to
control the transmitting/receiving packets.
• Port: Select the port that you want to configure.
• State: Current port status. The port can be set to Disable or Enable mode. When disabled, it will not
receive or transmit any packet.
• Negotiation: Auto and Force. Being set to Auto, the speed and duplex mode are negotiated
automatically. When you set it to Force, you have to assign the speed and duplex mode manually.
• Speed: It is available for selecting when the Negotiation column is set to Force. When the Negotiation
column is set to Auto, this column is read only.
• Duplex: It is available for selecting when the Negotiation column is set to Force. When the Negotiation
column is set to Auto, this column is read only.
• Flow Control: Set flow control function to Symmetric or Asymmetric in Full Duplex mode.
•
Click
A
pply
to have the configuration take effect.
Figure 3.1-17 Port Control
EKI-2548I_Manual_ed2 38