User manual

PCA-6742 User Manual 18

3.2.4 Advanced Chipset Feature

! SMI712 VGA Setting [Press Enter] (Show Only)

This item allows users to set VGA related features.

! EVA-X4300 IDE Legacy mode [Enabled]

This item enables EVA-X4300 IDE as legacy IDE controller or PCI IDE controller.

! Watch Dog Timer reset [Disabled]

This item allows user to set watch dog timer.

! Do CMOS Clear [Disabled]

This item allows user to clear CMOS.

! LAN Controller [Enabled]

This item is enabled or disabled that onboard of LAN controller.

! GPCS0 FUNCTION [Disable]

This item allows users to use the GPCS (General Purpose Chip Select) function to

detect ISA cards.

EVA-X4300 defines two general-purpose chip select output pins with programmable

address and range of memory and I/O access. It also can be programmed as mem-

ory activated or by I/O read / write command. If necessary, this can be used to

generate a de-asserted signal, and the system control logic samples can iden-

tify the addressed expansion board through this BIOS setting.

! GPCS COMMAND [MEMRW 16 Bits]

Select 8 Bits or 16 Bits I/O or Memory card.

! GPCS Start Address [Press Enter]

Setting ISA card decode start address.

! GPCS Mask Compare Bit [Press Enter]

Setting ISA card rang.

Ex: FFFFFFF0h mean range is 16bytes, if FFFFFF00h mean range is 256 bytes.

Note! This “Advanced Chipset Features” page controls configuration of the

board’s chipset; this page is chipset dependent. Use it to control chipset

mended only technical users make changes to the default settings.