User manual

17 Appendix A
A.2 Installation of Resistive Touchs c r e e n D r i v e r
The resistive touchscreen in the FPM-3190 Series provides drivers for
use with Windows 2000 and XP. For the detailed installation procedure
for the resistive touchscreen drivers, please refer to the CD-ROM Touch-
Screen-DRV\Penmount 9000(resistive) folder.
Before installing the Windows 2000/XP driver software, you must have
the Windows 2000/XP system installed and running on your computer.
You must also have one of the following PenMount Serial Interface con-
troller boards installed: 90A4, 9026B, 9036 or 9084. Contents of the Pen-
Mount Windows 2000/XP driver folder are listed below.
DMC9000.inf
DMC9000.sys
DMC9000.cat
SETUP.EXE
If you have an older version of the PenMount Windows 2000/XP driver
installed in your system, please remove it first. Follow the steps below to
install the PenMount Windows 2000/XP driver.
1. When the system first detects the controller board, a screen appears
that shows “Unknown Device.” Do not use this hardware wizard.
Press Cancel.
Note 1: The following windows illustrations are examples
only. You must follow the flow chart instructions
and pay attention to the instructions which then
appear on your screen.