User manual

21 Appendix A
Multiple monitors, serial controllers
1. Follow the general procedure for Single monitor, serial controller
installation above, auto detecting or selecting all the serial ports
that you will use.
2. The driver files will install. When the "Setup Complete" screen
appears, you may choose to run calibration (the Elo Video Align-
ment program, EloVA) immediately or wait until later. If you
choose not to run this program now, you can run it from the Elo
Control Panel application. When EloVA runs for the first time, it
will attempt to calibrate all controllers and/or serial ports that were
installed. Press the Esc key on the keyboard to terminate or skip
calibration for any monitor, or allow the program to time out (as
indicated by the progress bar reaching maximum).
Multiple monitors, USB controllers
1. Follow the procedure for Single monitor, USB controller installa-
tion above.
2. The driver files will install. When the "Setup Complete" screen
appears, you may choose to run calibration (the Elo Video Align-
ment program, EloVA) immediately or wait until later. If you
choose not to run this program now, you can run it from the Elo
Control Panel application. When EloVA runs for the first time, it
will attempt to calibrate all controllers and/or serial ports that were
installed. Press the Esc key on the keyboard to terminate or skip
calibration for any monitor, or allow the program to time out (as
indicated by the progress bar reaching maximum). The program
will continue until all controllers and/or ports have been calibrated.