User manual

GMB-910 User Manual 36
 Power Management [User Define]
This item allows user to select system power saving mode.
 Video Off Method [DPMS]
This item allows user to determine the manner is which the monitor is blanked.
 Video Off In Suspend [Yes]
This item allows user to turn off Video during system enter suspend mode.
 Suspend Type [Stop Grant]
This item allows user to determine the suspend type.
 Modem use IRQ [3]
This item allows user to determine the IRQ which the MODEM can use.
 Suspend Mode [Disabled]
This item allows user to determine the time of system inactivity, all devices
except the CPU will be shut off.
 HDD Power Down Mode [Disabled]
This item allows user to determine the time of system inactivity, the hard disk
drive will be powered down.
 Soft-Off by PWR-BTTN [Instant-Off]
This item allows user to define function of power button.
 Wake up by PCI card
This item allows user to Wake up the system by PCI card. The choices are
“Enabled” and “Disabled”.
 Power on by ring [Enabled]
This item allows you to wake up the system via COM port from the remote host.
The choices: "Enabled", "Disabled".
 USB KB Wake_Up From S3 [Disabled]
This item allows user to set USB keyboard wake up system from S3 Enable or
Disable.
 Resume by Alarm [Disabled]
The choices are “Enabled” and “Disabled”. Fields that follow below indicate date
of current month and time of alarm settings, if enabled.
 Primary IDE 0 (1) and Secondary IDE 0 (1) [Disabled]
When Enabled, the system will resume from suspend mode if Primary IDE 0 (1)
or Secondary IDE 0 (1) becomes active. The choices are “Enabled” and “Dis-
abled”.
 FDD, COM, LPT PORT [Disabled]
When Enabled, the system will resume from suspend mode if the FDD, inter-
face, COM port, or LPT port is active. The choices are “Enabled” and “Disabled”.
Min Saving Minimum power management. Suspend Mode=1 hr.
Max Saving Maximum power management. Suspend Mode=1 min.
User Define Allows user to set each mode individually. Suspend Mode= Dis-
abled or 1 min ~1 hr.
V/H SYNC+Blank This option will cause system to turn off vertical and horizontal syn-
chronization ports and write blanks to the video buffer.
Blank Screen This option only writes blanks to the video buffer.
DPMS Initial display power management signaling.
Instant-Off Press power button then Power off instantly.
Delay 4 Sec Press power button 4 sec. to Power off.