Unit installation

INSTALLATION INTRAC-305
Page 70 INTRAC-305 MANUAL - Issue 3.2 ©2011 Advantech Wireless
Stp-Trk Inputs / Alarm outputs
25 way D type
Signal Name
1
Hi Ch1 I/P *
2
Lo Ch1 I/P *
3
Hi Ch2 I/P *
4
Lo Ch2 I/P *
10
Fault / Power-Off
11
Fault Common
12
OK
Note All other pins of the 25 way connector are unused.
Note * In the INTRAC-305 only one external input is implemented.
As delivered this will be channel 1 (Primary Beacon). If it is
required to use channel 2 (Secondary Beacon) input instead,
the internal cable from connector J37 on the INTRAC
Interface pcb to the rear panel pcb connector J3 should be
moved to rear panel pcb connector J2.
Communication Ports There are three serial communication ports on the INTRAC-
305, “Remote Port”, “Test Port 1” and “Test Port 2”. The
Remote Port is configured for RS232/RS423. Test Port 1&
Test Port 2 can be independently configured as either RS423
or RS422.
The pin allocations for both are given in the tables below.
Remote Port
25 way D type
Signal Name
2
Tx Data (I/P to INTRAC)
3
Rx Data (O/P from INTRAC)
4
RTS
5
CLS
7
GND
Note 1 All other pins of the 25 way connector are unused.
Note 2 RTS & CTS are linked via jumper J18.
Note 3 For remote operation the Advantech AMT Limited remote
terminal software package, RCM-4, is required.