Specifications

Front Panel Monitoring & Control
3.1 Introduction
The SBM75e Modulator is equipped with an active front panel (LCD screen and keypad) which
provides an easy way to setup the Modulator without the need for a PC or generic control
system. This chapter is intended to allow maintenance personnel or users to quickly set up the
Modulator for initial use.
Board Temperature:
LED Test:
Fan Speed:
Settings >(para. 3.3.2.3)
Output Power:
Output Enable:
CW Mode:
Ref. Setting:
Ref. Internal Ref.:
Ref. Store to ini:
BISS->(para. 3.3.2.5)
Status>
State:
Key State:
Processing:
Extraction:
Stream Info:
PMT Info:
Configure>
Mode:
Processing:
Insertion Period:
Session word:
Injected ID:
Encrypted Word:
Active Key:
Even Session Word:
Odd Session Word:
Even ESW:
ODD ESW:
Configure BISS>
Reboot card> (para. 3.3.2.6)
Reset to Factory defaults>(para. 3.3.2.7)
System Setup> (para 3.3.2.5)
Network Address:
Subnet Address:
Gateway:
Advantech AMT
TM
SBM-75
Press any key to continue.....
Switch On
Overview:
Select Board >
Chassis Info >
Set Brightness:
Overview : (para. 3.3.1)
Select Board > (para. 3.3.2)
Chassis Info > (para. 3.3.3)
Set Brightness : (para. 3.3.4)
Card Information
Version:
Support Features>
Feature list
Status > (para. 3.3.2.1)
Status >
FPGA:
Input:
Self test:
Prog Baud Rate:
Prog Bit Rate:
Actual Baud Rate:
Board Temp:
Core Temp:
Version:
Configure > (para. 3.3.2.2)
Profiles > (para. 5.3.2.2.1)
Load Profile >
Create Profile >
Delete Profile >
Reconfigure>
Coding > (para. 3.3.2.2.3)
Modulation :
Data Rate :
Input :
Redundant Input :
Input Type:
Reset Input On Error:
Pilots :
PRBS Polynomial :
Stream X > :
Input:
Redundant Input:
Block Size:
FEC Rate:
Modulation:
Pilots:
ISI:
PRBS Polynomial:
Rate limiter:
Cut off rate:
Packet Type:
ISSY Type:
Packet Length:
Packet Sync:
Reconfigure Stream:
Frequency:
Spectrum:
Alpha:
PLS Seed:
Reconfigure:
3-2 SBM75e Series Modulator Installation and Operation Manual