User manual

0x02 Front Panel RJ45
0x03 Front panel mini-USB (default)
0x04 RTM mini-USB
0x05 RTM RJ45
0x0F Automatic mode
Table 2: COM1 UART MUX settings
COM2 MUX:
Setting Connection
0x00 no interface connected, open
0x01 Serial-over-LAN (SOL)
0x02 Front Panel RJ45
0x03 Front panel mini-USB (default)
0x04 RTM mini-USB
0x05 RTM RJ45
Table 3: COM2 UART MUX settings
Important Note:
The COM1 UART is the main interface with higher priority! There is
an important dependency between COM1 and COM2 UARTs, users should know and
aware of:
The COM2 MUX can ONLY be used, if the COM1 MUX is set to SOL (0x01)! If the
COM1 MUX has any other settings than SOL, COM2 is permanently fixed to SOL and
the COM2 MUX OEM command setting is ignored.
Read COM port UART MUX setting:
Response:
Change COM port UART MUX setting:
Response:
39 28 00
ipmitool raw 0x2e 0x40 0x39 0x28 0x00 0x08 <port> <setting>
39 28 00 <setting>
ipmitool raw 0x2e 0x41 0x39 0x28 0x00 0x08 <port>