User manual
3 MIO-5251 User Manual
Chapter 1 General Information
* Supports Extend/ Clone Mode with multi-display device
* Dual display: any two combination between VGA, HDMI/DisplayPort/MIOe's
DisplayPort, LVDS/eDP
– Specification and Resolution
* VGA: 2560 x 1600 at 60Hz
* HDMI/DisplayPort: HDMI 1.4a with audio, up to 1080P at 60Hz. DisplayPort is
supported standard version 1.1a with audio, up to 2560x1600 at 60Hz
* LVDS/eDP: 48-bit dual channel LVDS up to WUXGA 1920x1200 at 60Hz
via
CH7511, eDP is supported standard version 1.3 with audio up to
2560 x1600 at 60Hz
* Inverter power: 1A @ 5V/12V
– 3D HW Acceleration: OGL4.0, DirectX 11.1
– HW Video Decode: H.264, MPEG2, VC-1, VP8
– HW Video Encode: H.264, MPEG2 (max at 1080p)
Gigabit Ethernet
– Controller: Intel
®
i210
* 10/100/1000 BASE-T
*
IEEE 802.3az Energy Efficient Ethernet (EEE), which defines Low Power Idle (LPI) state
* IEEE 1588/802.1AS precision time synchronization
* 9.5 KB Jumbo frames supported (Full-duplex)
* Flow Control supported
* Magic packet wake-up enable with unique MAC address
Peripheral interface
– MIOe Expansion
DisplayPort (Supported by T-P/N due to shared with the DisplayPort on rear I/O)
1 PCIe x1
3 USB 2.0
LPC
HD Audio: Line out
SMBus
Power: +5 Vsb/+12 Vsb, Power On, Reset
– 1 Serial-ATA port, up to 3.0Gb/s transfer rate (300 MB/s), supports indepen-
dent DMA operation
* SATA Power: 5V / 12V
– 1 x USB 3.0 & 4 x USB2.0
* One USB3.0 and three USB2.0 on rear I/O, one internal USB2.0
* USB3.0 SuperSpeed (SS), implements xHCI software host controller interface
* Multiplexed with EHCI controller that are High-Speed/Full-Speed (HS/FS)
* USB source: USB3.0 and USB2.0's dual port on rear I/O's USB signal directly
from CPU, USB2.0 dual port on rear I/O + internal USB + mini PCIe from USB
hub1, mSATA + 3xUSB3.0 for MIOe from USB hub2
* Support wake-up from sleeping state S3
* Power supply: 0.5A @ 5V for USB2.0, 1A @ 5V for USB3.0
– 2 RS-232 for COM1/2, 2 RS-232/422/485 for COM3/4 (ESD protection: air
gap ±15kV, contact ±8kV
– 8-bit Programmable General Purpose Input/ Output from iManager (5V tolerance)
– 1 SMBus / I
2
C channel from iManager
– Watchdog timer: Output System Reset, Programmable counter from 1 ~ 255
minutes/ seconds
– Mini PCIe / mSATA
1 Full-size Mini PCIe with SIM holder (with PCIe and USB interface)
1 Full-size mSATA (with SATA and USB interface)
Power supply: 1.1 A @ 3.3 V, 0.375 A @ 1.5 V