User`s manual

42/61 MT-100 Tablet PC User Manual
Chapter 4 Touch screen Interface
4.1 Introduction
4.1.1 General Information
The MT-100's optional touch screen incorporates advanced second-generation 5-wire resistive
technology. They allow 75% light transmission respectively. The resistive and capacitive models have
an antiglare surface. All models provide greatly enhanced visual resolution. They also have new
improved scratch-resistant features.
The touch screen is manufactured from UL-recognized components. When properly installed, the touch
screen's ball impact resistance meets the UL 1950 standard. Its fire resistance meets the UL-746C, 19
mm (0.75") flame test standard. Systems incorporating the touch screen, controllers, and cables have
been approved to FCC Class A and Class B standards.
4.1.2 General specifications
Please refer to Chapter 1, Section 1.2 of this manual.
4.1.3 Environmental specifications
Temperature:
-0° ~ 40° C (operating)
-20° ~ 60° C (storage)
Relative humidity:
90 RH at 35° C (operating)
90 RH at 35° C for 240 hours, non-condensing (storage)
Chemical resistance: The active area of the touch screen is resistant to the following chemicals when
exposed for a period of one hour at a temperature of 21° C (71° F):
- Acetone
- Methylene chloride
- Methyl ethyl ketone
- Isopropyl alcohol
- Hexane
- Ammonia-based glass cleaners
- Turpentine
- Mineral spirits
- Foods and beverages
4.2 Installation of Driver for Touchscreen
MY-100 applies EETI to control touch screen. To facilitate installation of the touch screen driver, you
should read the instructions in this section carefully before you attempt installation.
Important The following windows illustrations are examples only. You must follow the flow
chart instructions and pay attention to the instructions which appear on your
screen.
Note1 The external CD-ROM drive is designated as “D” throughout this chapter.
Note2 <Enter> means pressing the “Enter” key on the keyboard.