User`s manual

24 PCA-6154/6154L User's Manual
2.10 Ethernet Configuration (PCA-6154 Only)
The PCA-6154 is equipped with a high performance 32-bit PCI-bus
Fast Ethernet interface which is fully compliant with IEEE 802.3u
100/10Base-T specifications. It is supported by all major network
operating systems and is 100% Novell NE-2000 compatible.
The medium type can be configured via the RSET8139.EXE program
included on the utility disk. (See Chapter 3 for detailed information.)
RJ-45A connector (CN8)
100/10BASE-T connects to the PCA-6154 via an adapter cable to the
RJ-45 standard jack.
Network boot
The Network Boot feature is built into the BIOS. It can be enabled/
disabled in the chipset setup of the CMOS configuration. Refer to
"BIOS Setting" in Chapter 4 for more information.
2.11 USB Connector (CN9)
The PCA-6154/6154L board provides two USB (Universal Serial
Bus) interfaces, which give complete plug and play, hot attach/detach
for up to 127 external devices.The USB interfaces comply with USB
specification rev. 1.0 and are fuse protected.
The USB interfaces are accessed through a 10-pin flat-cable connec-
tor, CN9. The adapter cable has a 10-pin connector on one end and a
USB connector on the bracket.
The USB interfaces can be disabled in the system BIOS setup.
2.12 IR Connector (CN5)
This connector supports the optional wireless infrared transmitting
and receiving module. This module mounts on the system case. You
must configure the setting through BIOS setup.