Specifications

Chapter 9 SCSI Setup and Configurations 109
mum speed. If you use a different kind of terminator plug, the data
I/O rate will decrease.
• By default, termination on the AIC-7892 itself is set to Automatic
(the preferred method). We recommend that you do not change this
default setting.
9.4 Configuring the SCSI Interface with
SCSI Select
SCSISelect, included with the AIC-7892, enables you to change SCSI
settings without opening the computer. SCSISelect also enables you
to low-level format or verify the disk media of your SCSI hard disk
drives. The following table lists the available and default settings for
each SCSISelect option.
Note: The default settings are appropriate for most
systems. Run SCSI Select if you need to change or
view curre nt set-tings, or if you would like to run
the SCSI disk utilities. See the descriptions of each
option starting on page 113.
SCSI Select Options Available Settings Default Setting
SCSI Bus Interface Definitions:
Host Adapter SCSI ID 0-15 7
SCSI Parity Checking Enabled, Disabled Enabled
Host Adapter SCSI Termination
LVD/SE Connectors Automatic, Automatic
Enabled,
Disabled
SE Connectors Automatic Automatic
Low On/High On
Low Off/High Off
Low Off/High On
Boot Device Options:
Boot SCSI ID 0-15 0
Boot LUN Number
1
0-7 0