Specifications

110 PCA-6180 User’s Manual
SCSI Select Options Available Settings Default Setting
SCSI Device Configuration:
Sync Transfer Rate (MBytes/sec) 160, 80.0, 53.4, 40.0, 160
32.0, 26.8, 20.0,
16.0, 13.4, 10.0,
ASYN
Initiate Wide Negotiation Yes, No Yes (Enabled)
Enable Disconnection Yes, No Yes (Enabled)
Send S tart Unit Command Yes, No Yes (Enabled)
Enable Write Back Cache
2
N/C (No Change) N/C (No
Yes, No Change)
BIOS Multiple LUN Support
2
Yes, No No (Disabled)
Include in BIOS Scan
2
Yes, No Yes (Enabled)
Advanced Configuration Options:
Reset SCSI Bus at IC Initialization Enabled, Disabled Enabled
Display <Ctrl> <A> Messages Enabled, Disabled Enabled
during BIOS Initialization
Extended BIOS Translation for Enabled, Disabled Enabled
DOS Drives > 1 GByte
Verbose/Silent Mode Verbose, Silent Verbose
Host Adapter BIOS Enabled Enabled
Disabled: Not Scan
Disabled: Scan Bus
Domain Validation
2
Enabled, Disabled Enabled
Support Removable Disks Under Disabled, Disabled
BIOS as Fixed Disks
2
Boot Only,
All Disks
BIOS Support for Bootable Enabled, Disabled Enabled
CD-ROM
2
BIOS Support for Int 13 Enabled, Disabled Enabled
Extensions
2
1
Setting is valid only if Multiple LUN Support is enabled.
2
Settings are valid only if host adapter BIOS is enabled.
9.5 Starting SCSI Select
Follow these steps to start SCSISelect:
1. Turn on or restart your system.
During the startup process, pay careful attention to the mes-sages
that appear on your screen.
2. When the following message appears on your screen, press the
Ctrl-A keys simultaneously (this message appears for only a few
seconds):