Specifications

Chapter 2 Connecting Peripherals

Connect the first hard drive to the other end of the cable. Wire 1 on the

cable should also connect to pin 1 on the hard drive connector, which

is labeled on the drive circuit board. Check the documentation that

came with the drive for more information.

Connect the second hard drive to the remaining connector (CN2 or

CN1), in the same way as described above.

Note: The PCA-6180 supports the Ultra ATA/100 interface

and requires special IDE cables as well as a soft-

ware driver to enable this function. See Chapter 7 for

more information.

2.3 Floppy Drive Connector (CN3)

You can attach up to two floppy disk drives to the PCA-6180's

onboard controller. You can use 3.5" (720 KB, 1.44/2.88 MB) drives.

The card comes with a 34-pin daisy-chain drive connector cable. On

one end of the cable is a 34-pin flat-cable connector. On the other end

are two sets of 34-pin flat-cable connector (usually used for 3.5"

drives). The set on the end (after the twist in the cable) connects to the

A: floppy drive. The set in the middle connects to the B: floppy drive.

2.4 Parallel Port (CN4)