User`s manual

Appendix B Touchscreen Driver Installation

B.5 OS/2 (MonitorMouse)

First, be sure OS/2 is installed and operating properly with your

mouse. We suggest that you prepare OS/2 installation disks or a

bootable DOS disk. By doing so, you can easily reboot from such

disks should an improper setting in CONFIG.SYS cause the system to

not work.

Five steps are required when installing MonitorMouse for OS/2

Step 1 - Configure your Controller

Step 2 - Copy the Software

Step 3 - Modify CONFIG.SYS

Step 4 - Install the Touchscreen Control Panel

Step 5 - Calibrate the Touchscreen

STEP 1 - CONFIGURE YOUR CONTROLLER

Verify your controller configuration. Elo typically ships touchscreen

controllers preconfigured for use with Elo software, including

MonitorMouse for OS/2. Configuration requires setting switches

and/or installing jumpers that determine controller operating

parameters. You will need these parameters when you install the

MonitorMouse for OS/2 driver software. For controller installation

instructions, refer to the IntelliTouch Product Manual or the

AccuTouch Product Manual.