User manual

53 PCE-5127/7127 User Manual
Chapter 3 AMI BIOS Setup
3.2.3.6 Graphics Configuration
Figure 3.28 Graphics Configuration
 Primary Display
Select which IGFX/PEG/PCI graphics device should be primary display or select
SG for switchable GFX.
 Internal Graphics
Keep IGD enabled based on the setup options.
 GTT Size
Select the GTT size.
 Aperture Size
Select the aperture size.
 DVMT Pre-Allocated
Select DVMT5.0 Pre-allocated (fixed) graphics memory size, up to 102 4 M,
used by the internal graphics device.
 DVMT Total Gfx Mem
Select 128 M, 256 M or MAX DVMT5.0 total graphics memory size used by the
internal graphics device.
 Gfx Low Power Mode
This option is applicable for SFF only.
 Primary IGFX Display
Select the video device which will be activated during POST. This has no effect
if external graphics present. Secondary boot display selection will appear based
on your selection. VGA modes will be supported only on primary display. note:
In DOS mode, only support either VGA or DVI single output.