User manual

Signal Conditioning Modules and Terminal Boards
ADAM-3000 Series
Introduction
The ADAM-3000 Series consist of the most cost-efficient,
field configurable, isolation-based, signal conditioners
on the market today. The modules are easily installed to
protect your instruments and process signals from the
harmful effects of ground loops, motor noise, and other
electrical interferences.
Affordable Signal Isolation Solution
Featuring optical isolation technology, the ADAM-3000
modules provide three-way (input/output/power) 1,000
V
DC
isolation. Optical isolation provides pin-point accuracy
and stability over a wide range of operations at minimal
power consumption.
Flexible Analog Data Conversion
The input/output range for the ADAM-3000 modules can
be configured through switches located inside the module.
The modules accept voltage, current, thermocouple or RTD
as input, and pass voltage or current as output.
Thermocouple input is handled by the built-in input
thermocouple linearization circuitry and a cold junction
compensation function. These ensure accurate temperature
measurement and accurate conversion of this information
to the voltage or current output.
Features
 1,000 V
DC
three-way isolation
 Easy input/output range configuration
 Flexible DIN-rail mounting
 Linearized thermocouple/RTD measurement
 Low power consumption
 Wide input bandwidth
Common Specifications
 Isolation 1,000 V
DC
 Indicators Power LED indicator
 Power Requirement 24 V
DC
± 10%
 Case ABS
 Screw Terminal Accepts 0.5 mm² ~ 2.5
mm
2
1- #12 or 2- #14 ~ #22
AWG
 Operating Temperature 0 ~ 70°C (32 ~ 158°F)
(ADAM-3011: 0 ~ 50°C
(32 ~ 122°F))
 Storage Temperature -25 ~ 85°C
(-13 ~ 185°F)
Configuration
The ADAM-3000 modules use 24 V
DC
power. This electrical
power wiring can be acquired from adjacent modules,
which greatly simplifies wiring and maintenance. The I/O
configuration switches are located inside the modules.
To reach the switches, simply remove the modules from
the DIN-rail bracket by sliding the modules downward.
Modular Industrial Design
The ADAM-3000 modules can be easily mounted on
a DIN-rail, and signal wires can be connected through
screw terminals. The screw terminals and input/output
configuration switches are built inside the industrial
grade plastic casing. With simple two-wire input/output
cables, wiring is easy and reliable in harsh industrial
environments.
Applications
 Signal isolation
 Signal transmitters
 Thermocouple/RTD/strain gauge measurements
 Signal amplifiers
 Noise filter
20-2