User manual

7 PCI-1750 User Manual
Chapter 2 Installation
2.3 Location of Connectors
Figure 2.1 shows the names and locations of connectors on the board.
The PCI-1750 is a plug and play device. The PCI BIOS assigns the system resources
automatically at system start-up. All functions can be set by software. One jumper
and one switch are used on this card. .
Figure 2.1 Location of Jumper and DIP switch
The default configuration after the power is switched on, and the hardware has been
reset is to set all the isolated output channels to “open” (the current of the load can’t
be sinked) so that users do not have worry about damaging external devices during
system startup or reset.
When the system is hot reset, then the status of the isolated digital output channels
are selected by jumper JP2. Table 2-1 shows the configuration of jumper JP2.
Table 2.1: JP2 : Power on configuration after hot reset
JP2 Power on configuration after hot reset
Default configuration
Keep last status after hot reset