User manual
Manuals
Brands
Advantech Manuals
Computer equipment
PCIE-1756
11
12
13
14
15
16
17
18
19
20
Table Of Contents
Chapter 1 Introduction
1.1 Features
1.2 Applications
1.3 Installation Guide
Figure 1.1: Installation Flow Chart
1.4 Software Overview
1.5 DAQNavi Device Driver Programming Roadmap
1.6 Accessories
Chapter 2 Installation
2.1 Unpacking
2.2 Driver Installation
Figure 2.1: Setup Screen of Advantech Automation Software
Figure 2.2: DAQNavi Installation Setup Screen
2.3 Hardware Installation
2.4 Device Setup & Configuration
Figure 2.3: The Device Setting of PCIE-1756
Figure 2.4: The Digital I/O Setting Page
Figure 2.5: The Device Testing of PCIE-1756
Chapter 3 Signal Connections
3.1 Overview
3.2 Switch and Jumper Settings
Figure 3.1: Connector and Switch Locations
3.2.1 Board ID (SW1)
Board ID Setting (SW1)
3.2.2 Power On Configuration(JP1)
Power on configuration after hot reset (JP1)
3.2.3 Channel-Freeze Function (JP2)
Channel-Freeze Function Input Mode (JP2)
3.3 Signal Connections
Figure 3.2: I/O Connector Pin Assignments
3.3.1 I/O Connector Pin Definition
I/O Connector Signal Descriptions
3.3.2 Isolated Digital Input
Figure 3.3: Isolated Digital Input Connection
3.3.3 Isolated Digital Output
Figure 3.4: Isolated Digital Output Connection
3.3.4 Channel-Freeze Function
Figure 3.5: Wiring in wet contact input mode
Figure 3.6: Wiring in dry contact input mode
3.4 Field Wiring Considerations
Appendix A Specifications
A.1 Isolated Digital Input
A.2 Isolated Digital Output
A.3 General
Appendix B Block Diagrams
Appendix C ADAM-3951 Pin Assignment
Figure C.1: Connect to PCL-10250 CON1
Figure C.2: Connect to PCL-10250 CON2
2
CHAPTER
2
Inst
allation
This chapter provides a packaged item
checklist, proper instructions for
unpacking and step-b
y-step procedures
for both driver and card installation.
Sections include:
• Unpacking
• Driver Installation
• Hardware Installation
• Device Setup & Configuration
1
...
...
17
18
19
20
21
...
...
46
