Specifications

20 PCL-846/847 User's Manual

Operating Environment Selection

Set jumper 15 (JP15) to correspond with your desired software

operating environment. Connect the left two pins of JP15 to operate in

DOS or Windows 3.1 mode, as shown below. Connect the right two

pins to operate in Windows 95 or Windows NT mode .

JP15 JP15

DOS, Windows 3.1 Windows 95, Windows NT

Driver Installation for DOS Users

Make a duplicate copy of the driver diskette in case the original disk

becomes lost or damaged. Copy the files to a subdirectory on your

hard disk if you wish.

The PCL-846/847 comes with the PC-ComLIB software package. PC-

ComLIB provides software drivers for DOS which supports most

common languages, including C, PASCAL, BASIC, Quick BASIC,

Assembly and Clipper. PC-ComLIB also includes the DataScope data

viewer, terminal emulator and self-diagnostics utilities for easy

troubleshooting and debugging. Please see the PC-ComLIB manual

for detailed information.

Card setup

The PCL-846/847's driver determines the configuration of the

installed cards by reading a data file, GEN-DRV.CNF. When you

first install the PCL-846/847, and each time you change the card's

address and IRQ, you will need to run the card setup program to save

the settings to the configuration file.

Program files should be installed to the hard disk. Insert the driver

disk in your computer, type DOSINST from the A: (or B:) prompt and

press enter. Once the files have been installed, type SETUP from the

\COMLIB\BIN prompt and press ENTER. You will then see the

screen on the following page.