Specifications

University of Hertfordshire
30
The setting of the MDS command determines whether the trace data is transferred as
one or two 8-bit bytes.
TDF M
TDF M is the measurement data format. The measurement data format transfers trace
data in measurement units, and the measurement data can range from 32768 to
+32767.

TRA/TRB/TRC (Trace Data Input and Output): The TRA/TRB/TRC commands provide a
method for returning, storing or changing the 16-bit trace values.

TS (Take Sweep): Starts and completes one full sweep before the next command is
executed.
6.2 Sgpib Programming Commands
Sgpib programming commands are used to control GPIB card.
Working commands:

CMD <data>: Send raw multiline CMD with ATN set

DATA <data>: Send data or commands to GPIB divice.

END: Send '\n' (switch a new line) with EOI

EOI <val>: Send a byte with EOI

GET: Group Execute Trigger

IFC: Clear Interface

LISTEN <adr>: Switch the device on the address to LISTEN state