User manual

POC-175 User Manual 78
C.3 Installing the 2.5" Hard disk drive (HDD)
You can attach one enhanced Integrated Device Electronics (IDE) hard
disk drive to the Point of Care Terminal’s internal controller which uses a
PCI local-bus interface. The following are instructions for installation:
1. Detach the HDD bracket by unscrewing the four screws (#2) on the
top of the HDD bracket.
2. Place the HDD inside the HDD bracket and tighten four screws
(#1) from both sides of the HDD bracket.
3. The HDD cable (1 x 44-pin to 1 x 44-pin) is next to the HDD
bracket. Connect the HDD cable to the POC-175. Make sure that
the red wire corresponds to Pin 1 on the connector (CN6), which is
labeled on the board. Plug the other end of the cable into the HDD,
with Pin 1 on the cable corresponding to Pin 1 on the HDD.
Figure C.2: Installing the primary 2.5" HDD