User manual

9 POC-S195 User Manual
Chapter 2 System Setup
Figure 2.2: Rear view of the Point-of-Care Terminal
2.2 2.2 Installation Procedures
2.2.1 Connecting the Power Cord
The POC-S195 can only be powered by a DC power adapter (SINPRO Model no.
MPU100-108). Be sure to always handle the power cords by holding the plug ends
only.
Follow these procedures in order:
1. Connect the female end of the power adapter to the DC jack of the panel PC.
(See Figure 2-3.)
2. Connect the female end of the power cord to the DC power adapter
3. Connect the 3-pin male plug of the power cord to an electrical outlet.