User manual

POC-S195 User Manual 20
4.1 Introduction
The POC-S195 has an onboard flat panel interface. The specifications and features
are described as follows:
4.1.1 4.1.1 Chipset
The POC-S195 uses an Intel 855GME for its graphic controller. It supports LVDS
LCD displays, and standard progressive scan analog monitors.
4.1.2 4.1.2 Display Memory
The 855GME chip, the VGA controller can drive a standard progressive scan analog
monitor with resolutions up to 1600 x 1200 at 85-Hz and 2048 x 1536 at 75-Hz, and
color panel displays in LVDS models with resolutions up to UXGA panel resolution
with a frequency range from 25 MHz to 112 MHz.
4.1.3 4.1.3 Display Types
Analog displays and LCD panel display can be used simultaneously. The POC-S195
can be set in one of three configurations: CRT only, LVDS only, both CRT and LFP
(LVDS). The system is initially set to simultaneous display mode - CRT and LFP
(LVDS).
4.2 Installation of the PCI Graphic Driver
Complete the following steps to install the Integrated Graphic Controller driver. Fol-
low the procedures in the flow chart that apply to the operating system that you are
using within your POC-S195.
Note!
The following Windows illustrations are examples only. You must follow the flow
chart instructions and pay attention to the instructions which appear on your
screen.
Note!
The CD-ROM drive is designated as ‘D’ throughout this chapter.
Note!
<Enter> means pressing the ‘Enter’ key on the keyboard.
Note!
Before you install the POC-S195 graphic driver, please ensure you have
installed the INF driver for the Intel 855GME chipset. You can find this driver in
the Utility CD-ROM.