User manual

POC-S195 User Manual 28
6.1 Introduction
6.1.1 General Information
The POC-S195's optional touchscreen incorporates advanced second-generation 5-
wire resistive technology. They allow 75% light transmission respectively. The resis-
tive and capacitive models have an antiglare surface. All models provide greatly
enhanced visual resolution. They also have new improved scratch-resistant features.
The touchscreen is manufactured from UL-recognized components. When properly
installed, the touchscreen's ball impact resistance meets the UL 1950 standard. Its
fire resistance meets the UL-746C, 19 mm (0.75") flame test standard. Systems
incorporating the touchscreen, controllers, and cables have been approved to FCC
Class B standards.
6.1.2 6.1.2 General Specifications
Please refer to Chapter 1, Section 1.2 of this manual.
6.1.3 6.1.3 Environmental Specifications
Temperature:
0° ~ 40° C (operation)
-20° ~ 60° C (storage)
Relative humidity:
90 RH at 35° C (operation)
90 RH at 35° C for 240 hours, non-condensing (storage)
Chemical resistance: The active area of the touchscreen is resistant to the following
chemicals when exposed for a period of one hour at a temperature of 21° C (71° F):
- Acetone
- Methylene chloride
- Methyl ethyl ketone
- Isopropyl alcohol
- Hexane
- Ammonia-based glass cleaners
- Turpentine
- Mineral spirits
- Foods and beverages
6.2 6.2 Installation of Driver for Touchscreen
The POC-S195 applies EETI SAT5000UR to control the touchscreen. To facilitate
installation of the touchscreen driver, you should read the instructions in this section
carefully before you attempt installation.
Note!
Please note this function is set to ‘Disabled’ as a default. Please push the touch
on-off button once to enable if the POC touchscreen is originally set to off.