User manual

POC-S195 User Manual 56
C.1 Overview of Hardware Installation and
Upgrading
The Slim Point-of-Care Terminal consists of a PC-based computer that is housed in a
plastic rear panel and a metal shielding case. Your HDD, DDR DRAM, and so on are
all readily accessible by removing the rear panel and shielding case. Any mainte-
nance or hardware upgrades can be easily completed after removing the rear panel
and shielding case.
C.2 Installing the 2.5" Hard Disk Drive (HDD)
You can attach one enhanced Integrated Device Electronics (IDE) hard disk drive to
the Point-of-Care Terminal's internal controller which uses a PCI local-bus interface.
The following are instructions for installation:
1. Detach the HDD bracket by unscrewing the four screws (#2) on the top of the
HDD bracket.
2. Place the HDD inside the HDD bracket and tighten four screws (#1) from both
sides of the HDD bracket.
3. The HDD cable (1 x 44-pin to 1 x 44-pin) is next to the HDD bracket. Connect
the HDD cable to the POC-S195. Make sure that the red wire corresponds to
Pin 1 on the connector (CN6), which is labeled on the board. Plug the other end
of the cable into the HDD, with Pin 1 on the cable corresponding to Pin 1 on the
HDD.
Note!
The color LCD display installed in the Point-of-Care Terminal is high quality and
reliable. However, it may contain few defective pixels which do not always illu-
minate. With current technology, it is impossible to completely eliminate defec-
tive pixels. Advantech is actively working to improve this technology.
Warning! Do not remove the plastic rear cover until you have verified that no
power is flowing through the panel PC.
Power must be switched off and the power cord must be unplugged.
Every time you service the panel PC, you should be aware of this.