User`s manual

Chapter 9 Award BIOS Setup 121
ECP Mode Use DMAECP Mode Use DMA
ECP Mode Use DMAECP Mode Use DMA
ECP Mode Use DMA
You can choose different DMA modes for data transfer.
The options are: 3 (Default), 1.
PS/2 mouse functionPS/2 mouse function
PS/2 mouse functionPS/2 mouse function
PS/2 mouse function
When enabled, the PS/2 mouse is activated.
The options are: Disabled (Default), Enabled.
USB ControllerUSB Controller
USB ControllerUSB Controller
USB Controller
When enabled, the USB devices are activated.
The options are: Disabled (Default), Enabled.
EtherEther
EtherEther
Ether
net Boot ROMnet Boot ROM
net Boot ROMnet Boot ROM
net Boot ROM
When enabled, your system will be able to boot up through the Ethernet.
The options are: Disabled (Default), Enabled.
Panel TPanel T
Panel TPanel T
Panel T
ypeype
ypeype
ype
The panel type is designated by the manufacturer, according to your LCD
panel type.
9.11 Password Setting
To enable the password setting, select the item from the Standard CMOS
Setup. You will be prompted to create your own password. Type your
password up to eight characters and press "Enter". You will be asked to
confirm the password. Type the password again and press "Enter". You may
also press "Esc" to abort the selection and not enter a password. To disable
the password, press "Enter" when you are prompted to enter the password. A
message will appear, confirming the password is disabled.
Under the BIOS Features setup, if "System" is selected under the Security
Option field and the Supervisor Password is enabled, you will be
prompted for the supervisor password every time you try to enter the CMOS
Setup utility. If "System" is selected and User Password is enabled, you will
be requested to enter the user password every time you reboot the system. If
"Setup" is selected under the Security Option field and User Password is
enabled, you will be prompted only when you reboot the system.