User`s manual

156 PPC-150 User’s Manual
7. Unscrew the four screws on the power supply board. The power supply
board can be detached from the plastic housing after unplugging the
cables from the motherboard.
8. Remove the front panel by hand.
9. Unscrew the ten screws on the LCD holding plate to seperate the plastic
housing and LCD holding plate.The LCD inverter can also be detached
by unscrewing the three screws at the bottom (Toshiba LCD only).
10. Detach the plastic housing.
11. Detach the LCD by unscrewing the four screws located on the each
corners.
12.The touchscreen is stuck on the LCD holding plate by a strongly double-
side adhensive tape. We do not recommend you to remove it unless the
touchscreen is defective and you would like to replace it.
Note: Because of the modular design of the LCD and touch-
screen, you do not disassemble the whole system step by
step if you would like to replace the defective LCD or
touchscreen. You just start disassembling the module from
the step 8. Then you can easily remove the LCD and
touchscreen by step 9 to step 12.