User`s manual

Appendix E Mounting Instructions 181
E.3 Desktop Stand Mounting
The PPC-150 has a customized stand suitable for desktops and other horizon-
tal locations. A unique spring inside the stand enables the panel PC’s vertical
tilt to be adjusted about 30 degrees. The stand is available from Advantech
Co.
Follow these procedures to set up the stand:
1. Remove the rear cover of the panel PC by unscrewing the seven screws.
2. Attach the holding plate of the stand to the inside of the rear cover of the
panel PC using the five screws provided. (See Fig. E-4) The PPC-153 can
be mounted on a unique swingarm. This versatile accessory is easy to
install and operate, and can be rotated through a wide range of angles. Its
dimensions are shown in Figure E-5 below, and it is available from
Advantech Co., Ltd..)
3. Reattach the rear cover of the panel PC.
4. Attach the main body of the stand to the rear cover of the panel PC using
the four screws provided.
5. Slide the main body of the stand into the stand base. Tighten it with the
two screws provided.
6. Attach the rear cover of the stand to the main body of the stand by
snapping the lugs of the rear cover into the slots of the main body. When
the rear cover locks into place, you will hear a click.
7. Attach the top cover of the stand to the main body of the stand by
snapping the lugs of the top cover into the slots of the main body. The
cover must be rotated as it is snapped into place. When the top cover
locks into place, you will hear a click.
Note: The base of the stand has two plastic caps. If you pry off
the caps, you can attach the stand to your desktop using
the two screw holes.