User`s manual

Chapter 2 System Setup

2.2 Preparing For First-time Use

Before you start to set up the panel PC system, you should have at

least the following items ready:

• Power cord (in the accessory box)

• Y-shaped connector (in the accessory box)

• keyboard

• Mouse (for system software installation i.e. Microsoft Windows, NT,

etc.)

2.3 Installation Procedures

2.3.1 Connecting the power cord

The panel PC can only be powered by an AC electrical outlet (100 ~

250 volts, 50 ~ 60 Hz). Be sure to always handle the power cords by

holding the plug ends only.

Follow these procedures in order:

1. Connect the female end of the power cord to the AC inlet of the

panel PC. (See Fig. 2-5.)

2. Connect the 3-pin male plug of the power cord to an electrical

outlet.

Figure 2-5: Connecting the power cord

AC inlet

Electrical outlet

Power cord