User`s manual

PWS-1409/1419 User’s Manual

Pull up the small cage carefully

Connect the signal cable

The cable has pin 1 on the dot point

Push back the small cage

Pushback the small cage of floppy drive

Step 6. Connect the signal cable to the interface board by the same method

Step 4. Insert the floppy signal cable to slim floppy. Ribbon cables should always be con-

nected with the colored stripe (blue point on it) to Pin 1 on the connectors

Step 5. Push back the cage

Step 3. Pull up the small cage from the slim floppy disk

Step 7. Slant the interface board 180°, let the power connector upward

Step 8. Measure the length of the signal cable, tape it on the floppy driver

Step 9. Align the mounting holes and insert the screws# 2 to secure the floppy interface board

Tape the signal cable

Slant the interface 180°

Connect the cable to the interface card

the dots are the pin1 of cable

Secure the interface board with screw #2