Technical information

2
1
3
4
5
6
7
8
9
10
2
1
3
4
5
6
7
8
9
10
3/343/34
Selection guide (continued)
Ethernet network
Cabling system
ConneXium managed switches
Type of device Managed switches, 8 extended ports, copper twisted pair and fibre optic
Interfaces Copper cable ports Number and type 8 x 10/100BASE-TX ports 6 x 10/100BASE-TX ports 6 10/100BASE-T ports
Shielded connectors RJ45
Medium Shielded twisted pair, category CAT 5E
Total length of pair 100 m
Fibre optic ports Number and type – 2 x 100BASE-FX ports
Connectors – Duplex SC
Medium – Multimode optical fibre Single mode optical fibre
Length of optical fibre 50/125 µm – 5000 m (1) –
62.2/125 µm – 4000 m (1) –
9/125 µm fibre – – 32,500 m (2)
Attenuation analysis 50/125 µm fibre – 8 dB –
62.2/125 µm fibre – 11 dB –
9/125 µm fibre – – 16 dB
Ethernet services
FDR, SMTP V3, SNTP client, multicast filtering for optimization of the Global Data protocol,
configuration via Web access,VLAN, IGMP Snooping, RSTP (Rapid Scanning Tree Protocol),
priority port, data stream control, secure port
Topology Number of switches Cascaded Unlimited
Redundant in a ring 50 max.
Redundancy Redundant power supplies, redundant single ring, ring coupling,
rings supporting MRP, Fast Hiper Ring and RSTP
Power supply Voltage 18...60 V c
Consumption
10 W 12 W
Removable terminal block 2 terminal blocks, 2-way
Operating temperature 0...+ 60°C
Relative humidity 10…90% non-condensing
Degree of protection
IP 30
Dimensions W x H x D 120 x 137 x 115 mm
Mounting On symmetrical DIN rail, 35 mm wide
Weight 1 kg
Conformity to standards
IEC/EN 61131-2, IEC 61850-3, UL 508, UL 1604 class 1 division 2, CSA 22.2 No. 214 (cUL),
CSA 22.2 No. 213 class 1 division 2 (cUL), e, GL, C-Tick, LR, BV
LED indicators Power supply status, alarm relay status, active redundancy, redundancy management,
copper port status and copper port activity
Alarm relay Power supply fault, Ethernet network fault or communication port fault (volt-free contact
1 A max. at 24 V c, 2-way)
Reference
TCS ESM 083F23F1 TCS ESM 063F2CU1 TCS ESM 063F2CS1
Pages 3/46
1) Length dependent on the attenuation analysis and attenuation of the optical fibre
(typical value: 2000 m)
(2) Length dependent on the attenuation analysis and attenuation of the optical fibre
(typical value: 15,000 m)