User's Manual
Table Of Contents
- Table of Contents
- Preface
- Safety Instructions
- Rugged and Ready to Go
- Getting Started
- Installing the Rubber Bumpers
- Removing the Rubber Bumpers
- Using the Power Switch
- Inserting a Memory Card
- Removing a Memory Card
- Installing a 3G SIM Card
- Removing 3G SIM Card (optional)
- Installing a WWAN Module (optional)
- Installing an MSR (optional)
- Installing a 1D Barcode Scanner (optional)
- Installing an RFID (optional)
- Upgrading Components
- Making Connections
- Turning On
- Wireless Connections
- Using the Modules
- Using the Fingerprint Software
- Advanced Settings
- Troubleshooting
- Appendix
S10A User Manual
19
Replacing the CF/SSD/HDD Drive
1. Insert the CF/SSD/HDD drive into the slot with the
connector facing down.
2. Connect the CF/SSD/HDD connector.
3. Screw the left compartment cover back.
Removing the Battery
1. Make sure the system is turned off.
2. Move the power switch to the left to
ensure battery power is completely
cut off. See “Using the Power
Switch” on page 8.
3. Unscrew the battery
compartment cover.
4. Remove the battery connector.
5. Lift the battery off the
compartment.
SW1
Lock Lock
Lock Lock