SG-1003/1103 SOHO Security Gateway with 3 LANs User’s Manual
Copyright Advantech Co., Ltd copyrights this documentation and the software included with this product in 2002. All rights are reserved. Advantech Co., Ltd. reserves the right to make improvements in the products described in this manual at any time without notice. No part of this manual may be reproduced, copied, translated or transmitted in any form or by any means without the prior written permission of Advantech Co., Ltd. Information provided in this manual is intended to be accurate and reliable.
Safety Instructions 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Please read these safety instructions carefully. Please keep this User’s Manual for later reference. Please disconnect this equipment from AC outlet before cleaning. Don’t use liquid or sprayed detergent for cleaning. Use moisture sheet or clothe for cleaning. For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily accessible. Please keep this equipment from humidity.
e. The equipment has dropped and damaged. f. If the equipment has obvious sign of breakage. 16. CAUTION: THE COMPUTER IS PROVIDED WITH A BATTERY-POWERED REAL-TIME CLOCK CIRCUIT. THERE IS A DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURE. DISCARD USED BATTERIES ACCORDING TO THE MANUFACTURER’S INSTRUCTIONS.
Contents 1. Introduction 1.1 About the SG-1003/1103 1.2 Product Features 1.3 Hardware 1.4 Front Panel 1.5 Rear Panel 1.6 Packing Contents 2. Hardware Installation 2.1 Compact Flash Card Installation 2.2 RAM module Installation 2.3 Interface Connections 3.
CHAPTER Introduction 1
Chapter 1 Introduction 1.1 About the SG-1003/1103 A compact fan-less Security Gateway, the SG-1003/1103 is specifically designed for secure Internet connectivity and is suitable for SOHO Firewall/VPN applications. Designed with the SiS550 200 MHz processor, it has low power consumption that can meet the requirements needed for SOHO Firewall/VPN appliances.
1.4 Front Panel One LED indicates the power ON/OFF status.
1.
Figure 1-3 Rear Panel of the SG-1103 1. LAN1, LAN2, LAN3 ports The LAN port connectors are RJ-45 and support 10/100BaseTX Ethernet (10 Mbps/100 Mbps on a twisted pair cable). These ports are used for connecting LAN, WAN, DMZ. 2. COM ports The console port supports a data terminal equipment (DTE) interface (cable included) with 8 data bits, no parity, and 1 stop bit, the default speed is 38400 bps. 3. VGA port (SG-1103 only) This port is a standard VGA interface. Resolution supported is 1024 x 768.
1.
CHAPTER 2 Hardware Installation
Chapter 2 Hardware Installation 2.1 Compact Flash Card Installation 1. Using a screwdriver, remove the bottom cover. 2. Once removed, the CompactFlash card socket can be observed.
3. Insert the CompactFlash card into the socket. 4.
system operating. 2.2 RAM Module Installation 1. Using a screwdriver, remove the top cover 2.
3.
4. Once removed, you will see the SO-DIMM socket on the back side of CPU board.
5. Insert a SO-DIMM DRAM into the socket.
6. Make sure to assemble them before operating 2.3 Interface Connections Network Connection Connect a Twisted Pair Ethernet (TPE) network cable to the LAN ports. Power Connection Connect an AC to DC power adaptor to the power input port. The system accepts DC 5 V input only.
CHAPTER 3 Product Specifications
Chapter 3 Product Specifications • • • • • • • • • • • • • • CPU & Chipset: SiS550 200 MHz BIOS: AWARD 256 KB Flash memory System Memory: One 144-pin SO DIMM socket accepts up to 512 MB SDRAM Storage: one Compact Flash I/O: 1 x RS-232 port, 3 x RJ-45 LAN port, VGA, and PS2 Keyboard&Mouse Ethernet Chipset: RealTek 8139CL Operating temperature: 0 ~ 40° C (32 ~ 104° F) Power supply: AC/DC power adapter, DC 5 V input Storage temperature: -20 ~ 75° C (-4 ~ 167° F) Operating humidity: 5 ~ 95% @ 40 , non-condensi
